AML M3000 Betriebsanweisung PDF herunterladen (Seite 60)

M3000 Bar Code Reader User's Guide

5-18

output. You will be prompted to enter stamp commands only if the Input Type is S.

The Stamp Commands are:

M - Month (01-12)

D - Day of Month (01-31)

Y - Year (00-99)

H - Hour (00-23)

I - Minute (00-59)

S - Second (00-59)

W - Day of Week (0-6)

NOTE: The output during transmission will be two numeric digits for all the commands except

W, Day of Week. The Day of Week is output as one numeric digit, 0 being Sunday and 6

being Saturday.

For Example: To create a date stamp that outputs MM/DD/YY HH:MM, Enter S, as the Input

Type and enter the following Stamp Commands:

Stamp Commands

M//D//Y H:I

Field Requirements:

•

Stamp Commands are not required

• 0 to 31 characters allowed

Exhibit Text

This is a sequence of characters that is displayed on the screen only and does no user input. Enter

the text to be displayed. You will be prompted to enter Exhibit Text, only if the Input Type

Field Requirements:

•

Exhibit Text is not required

• 0 to 31 characters allowed

• alpha, numeric, and all other ASCII characters are accepted

NOTE: Any ASCII control character may be input by a 3 character sequence of "/nn" (/nn is the

HEX value of the character). Since a / is the start of any HEX value, you must type "//"

to output a slash. Refer to Appendix K for Special Character values.

Screen Usage Parameters

The following four parameters specify the portion of the screen used by the current input

definition. These parameters must be defined when using a Data Input, Yes/No Input, or Exhibit

Text.

NOTE: The M3000 prevents the operator from specifying a starting position greater than the

ending position. If the prompt text is greater than or equal to the window defined, the

M3000 displays only part of the prompt and allows one space for the input window.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 155 156

Keine Kommentare

AML M3000 Betriebsanweisung Seite 60