AML M3000 Betriebsanweisung PDF herunterladen (Seite 104)

M3000 Portable Bar Code Reader User's Guide

7-10

Once MONITOR receives data from the keyboard or a serial port, it will make the data appear in a

readable format (i.e. {F1} to represent the Function 1 key). MONITOR supports a wide range of

serial port options and also supports flow control via the XON/XOFF protocol.

Using MONITOR

Perform the following steps to run MONITOR:

1. Run the MONITOR Program by typing MONITOR from the DOS prompt and press the

ENTER key. For Example: C:\> MONITOR <ENTER>

2. Set up the serial port parameters to match your bar code reader or other serial output device

being used or select none to serial port option if no serial device is being used.

3. Press the ESC key to return to the main menu and select RECEIVE DATA and begin

transmission of data from device being diagnosed. Each key or serial data will be displayed

on the screen in a readable format. (i.e. {F1} to represent the Function 1 key).

4. Once transmission is complete, type key combination Ctrl + PrtSc to return to the main menu

where you may view, print, or save to a disk file, the data uploaded to MONITOR.

MONITOR Configuration

Communication Options Serial Port This option defines which serial port MONITOR will be

using. MONITOR supports both COM1 and COM2, or may be disabled by selecting none if

no serial device is to be used.

NOTE: If you have a serial port board which allows you to set the interrupt and port

addresses use the following assignments for COM1 and COM2:

COM1 COM2

Interrupt IRQ4 IRQ3

Port Address 3F8 Hex 2F8 Hex

BAUD Rate

This option defines the serial port transmission speed. MONITOR supports the following

transmission speeds:

300 600

1200 2400

4800 9600

19200 38400

NOTE: If you experience loss of data from the serial port, your BAUD rate may need to be

decreased.

Data Bits

This option defines the number of data bits used during serial communication. MONITOR

supports both 7 and 8 data bits.

Stop Bits

This option defines the number of stop bits used during serial communication. MONITOR supports

both 1 and 2 stop bits.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 155 156

Keine Kommentare

AML M3000 Betriebsanweisung Seite 104