Aml M2500 Decoder Bedienungsanleitung PDF herunterladen (Seite 6)

INSTALLATION INSTRUCTIONS

OVERVIEW

Installation requires connecting cables between the reader, your computer, and

terminal.

Step 1: Disconnect the existing RS-232 cable from the rear of the termi-

nal. (This cable is the serial cable originally connected between

the terminal and host computer system).

Step 2: The bar code reader comes with the following cable assemblies:

TERMINAL CABLE ASSEMBLY = 9 pin plug (male) to 25

pin plug (male)

HOST CABLE ASSEMBLY = 9 pin plug (male) to 25 pin

socket (female)

Plug the 9 pin end of the TERMINAL CABLE ASSEMBLY into the

connector labeled "TERMINAL" located on the rear panel of the

reader.

Step 3: Plug the other end of the TERMINAL CABLE ASSEMBLY (the 25 pin

male) into the rear of the terminal labeled "MODEM" or "MAIN".

Step 4: Plug the 9 pin end of the HOST CABLE ASSEMBLY into the

connector labeled "HOST" located on the rear panel of the reader.

Step 5: Plug the other end of the HOST CABLE ASSEMBLY (the 25 pin

female) into the original serial cable that was removed from the

terminal.

NOTE: Before installing the bar code reader, you must have an

operational RS-232 serial cable connected between the terminal

and host computer system. The terminal MUST be able to

communicate to the host system correctly BEFORE installing

the bar code reader.

1 2 3 4 5 6 7 8 9 10 11 ... 80 81

Keine Kommentare

Aml M2500 Decoder Bedienungsanleitung Seite 6